|
|
Instrumentation & Control Equipments
|
Suppliers Directory
|
SCR ELECTRONIKS
| | Address : |
W 188 (B) PHASE II MIDC DOMBIVILI (E) |
| Telephone : |
0251 2471778, 2461385 |
| Fax : |
0251 2471778 |
| Send : |
On-Line Trade Inquiry |
| |
|
Products |
|
SURGE COMPARISON TESTER - SCR ELECTRONIKS OFFERS A RANGE OF TEST PANELS FOR VARIOUS ELECTRICAL PARAMETERS. SURGE CMPARISON TESTER SCR MODEL SCT SERIES IS AN ADVANCED ELECTRONIC INSTRUMENT, WHICH IS USED TO TEST VARIOUS TYPES OF ELECTRICAL WINDINGS AND ELECTRIC MACHINES TO KNOW IF THERE IS ANY FAULT OR INSULATION DEFECT. IN THIS TEST HIGH VOLTAGE PULSE/SURGE IS APPLIED TO THE WINDING UNDER TEST AND VOLTAGE DECAY WAVEFORM IS COMPARED WITH WAVEFORM OF IDENTICAL WINDING. IF WINDING IS HEALTHY THEN BOTH WAVEFORMS WILL BE IDENTICAL. DEPENDING UPON THE TYPE OF DEFECT THE WAVEFORM WILL DIFFER. OBSERVING THE WAVEFORM ONE CAN IDENTIFY THE NATURE OF DEFECT. SURGE TESTER SCANS THROUGH THE ENTIRE INSULATION SYSTEM AND DETECTS INSULATION FAULTS SUCH AS TURN-TO-TURN; LAYER-TO LAYER; COIL-TO-COIL WINDING-TO-WINDING AND PHASE SHORTS AS WELL AS OPEN CIRCUITS AND GROUNDS. IT IS IDEAL FOR TESTING OF COILS, CHOKES STATOR, ARMATURE, ETC. IT IS AVAILABLE IN DIFFERENT RANGES LIKE 0-3 KV, 0-5 KV, 0-10 KV, ETC.
|
|
GLOW-WIRE APPARATUS - WITH THIS APPARATUS THE "RESISTANCE TO FIRE" IN THE MOULDED INSULATOR MATERIAL PARTS OF ELECTRICAL ACCESSORIES, LIKE DOMESTIC SWITCHES, MCB AND ELCB CAN BE TESTED. TESTING OF THE ELECTROTECHNICAL PRODUCTS WITH REGARD TO FIRE HAZARD IS TO CREATE EXACTLY THE CONDITIONS OCCURRING IN PRACTICE. HOWEVER, IN MOST INSTANCES, THIS IS NOT POSSIBLE. THUS, FOR PRACTICAL PURPOSES, THE TESTING OF ELECTROTECHNICAL PARTS/PRODUCTS IS DONE WITH REGARD TO FIRE HAZARD BY THE SIMULATING AS CLOSELY AS POSSIBLE THE ACTUAL EFFECTS OCCURRING IN PRACTICE. THIS TEST SETUP DOES CREATE SUCH SIMULATION AS DESCRIBED IN THE RESPECTIVE IS CODE: IS 11000 (PART 2/SEC 1) – 1984 AND IEC PUB 695-2-1 (1980), FIRE HAZARD TESTING – GLOW WIRE TEST AND GUIDANCE IS APPLICABLE TO SWITCHES FOR DOMESTIC AND SIMILAR PURPOSES AS WELL AS OTHER ELECTRO-TECHNICAL EQUIPMENTS.
|
|
COMMUTATOR TEST PANELS - SCR ELECTRONIKS OFFERS A RANGE OF TEST PANELS FOR VARIOUS ELECTRICAL PARAMETERS. COMMUTATOR TEST PANEL PROVIDES A SIMPLE AND SPEEDY METHOD FOR TESTING OF COMMUTATORS FOR HV TEST. THIS IS VERY USEFUL FOR COMMUTATOR MANUFACTURERS AS WELL AS MOTOR MANUFACTURERS. TWO TESTS, NORMALLY BAR TO BAR AT 500 V AC AND BAR TO SHAFT AT 1500 V ARE PERFORMED ONE AFTER ANOTHER AUTOMATICALLY. IN CASE THERE IS A FAULT THE TEST IS TERMINATED AND THE FAULT LOCATION IS INDICATED BY LOCATION OF TEST PROBES. SPECIALLY DESIGNED FIXTURE WITH MOTORISED ARRANGEMENT FACILITATES EASY LOADING AND REMOVAL OF COMMUTATORS.
|
|
FIRE RESISTANT TEST APPARATUS - SCR ELEKTRONIKS HAS DEVELOPED A GLOW-WIRE APPARATUS TO CARRY OUT TESTS SPECIFIED IN MANY STANDARDS TO CHECK THE "RESISTANCE TO FIRE"IN THE MOULDED INSULATOR MATERIAL PARTS OF ELECTRICAL ACCESSORIES, LIKE DOMESTIC SWITCHES, MCB, ELCB, ETC. TESTING OF THE ELECTRO-TECHNICAL PRODUCTS WITH REGARD TO FIRE HAZARD IS TO CREATE EXACTLY THE CONDITIONS OCCURRING IN PRACTICE. HOWEVER, IN MOST INSTANCES, THIS IS NOT POSSIBLE. THUS FOR PRACTICAL PURPOSES, THE TESTING OF ELECTRO-TECHNICAL PARTS/PRODUCTS ARE TESTED WITH REGARD TO FIRE HAZARD BY THE SIMULATING AS CLOSELY AS POSSIBLE THE ACTUAL EFFECTS OCCURRING IN PRACTICE. THIS TEST SETUP DOES CREATE SUCH SIMULATION AS DESCRIBED IN THE RESPECTIVE IS CODE: IS 11000 (PART 2/SEC1) - 1984 AND IEC PUB 695-2-1 (1980). IT IS APPLICABLE TO SWITCHES FOR DOMESTIC AND SIMILAR PURPOSES AS WELL AS OTHER ELECTRO-TECHNICAL EQUIPMENTS.
|
| |
|
View More Supplier Pages
Page(s) : 1 •
2 •
3 •
4 •
5 •
| |
|
|
|
